Replacing The Blade; Figure 37 - Toro Recycler 20334 Operator's Manual

Figure 36
1. Battery cover
2. Fuse
5. Replace the fuse in the fuse holder
Note: Your machine comes with a spare fuse attached
to the battery-charger box
2
1

Figure 37

1. Battery compartment
6. Install the battery compartment with the screw that
you removed in step 4.
7. Install the covering over the battery compartment.
8. Lower the rear deflector.
1
2
3
g030022
3. Fuse holder
(Figure 36).
(Figure 37).
g030053
2. Battery-charger box

Replacing the Blade

Service Interval: Yearly
Important: You will need a torque wrench to install the
blade properly. If you do not have a torque wrench or are
uncomfortable performing this procedure, contact an
Authorized Service Dealer.
Examine the blade whenever you run out of gasoline. If the
blade is damaged or cracked, replace it immediately. If the
blade edge is dull or nicked, have it sharpened and balanced,
or replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Refer to Preparing for Maintenance (page
2. Tip the machine onto its side with the dipstick down.
3. Use a block of wood to hold the blade steady
38).
4. Remove the blade, saving all mounting hardware
(Figure 38).
5. Install the new blade and all mounting hardware
(Figure 39).
19
16).
Figure 38
(Figure