Servicing The Air Filter; Changing The Engine Oil - Toro Recycler 20334 Operator's Manual

hand fuel pump to remove the fuel. Always tip the
machine onto its side, with the dipstick down.

Servicing the Air Filter

Service Interval: Every 25 hours
1. Upclip the top of the air-filter cover
Figure 31
1. Clip
2. Air-filter cover
2. Remove the air filter
3. Inspect the air filter.
Note: If the air filter is excessively dirty, replace it with
a new filter. Otherwise, gently tap the air filter on a
hard surface to loosen debris.
4. Install the air filter.
5. Use the clip to install the air-filter cover.

Changing the Engine Oil

Changing the engine oil is not required, but if you desire
to change the oil, use the following procedure.
Note: Run the engine a few minutes before changing the
oil to warm it. Warm oil flows better and carries more
contaminants.
Max. fill: 0.53 L (18 oz), type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or higher.
1. Refer to Preparing for Maintenance (page
2. Remove the dipstick
(Figure 31).
3. Air filter
(Figure 31).
16).
(Figure 32).
1. Dipstick
2. Add marker
3. Tip the machine onto its side with the air filter up to
drain the used oil out through the oil-fill tube
33).
4. Slowly pour oil into the oil-fill tube until the oil level
reaches the Full line on the dipstick
not overfill.
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
17
Figure 32
3. Full marker
Figure 33
(Figure
(Figure
32). Do