Maintenance - Toro 09801 Operator's Manual

Maintenance

LUBRICATION
To avoid personal injury from inadvertent start up or
contact with a hot surface, stop the engine, remove the
key from the switch and wait for the unit to cool before
servicing or making adjustments of the machine.
The Hydroject 3000 has 5 grease fittings that must be lubricated
every 25 hours of operation with No. 2 General Purpose Lithium
Base Grease.
The bearings and bushings that must be lubricated are: steering
pivot shaft (Fig.14), limit switch housing (Fig. 15) (2) on lift
arm shaft (Fig. 15) and neutral pivot shaft (Fig. 16).
1. Wipe the grease fitting clean so foreign matter cannot be
forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe up excess grease.
CAUTION
Figure 14
Figure 15
Figure 16
25