Toro 03422TE Operator's Manual page 23

GREASING BEARINGS AND BUSHINGS
(Fig. 20–26)
The traction unit and cutting unit's grease fittings must
be lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated under
normal conditions, lubricate bearings and bushings after
every 50 hours of operation. Bearings and bushings
must be lubricated daily when operating conditions are
extremely dusty and dirty. Dusty and dirty operating
conditions could cause dirt to get into the bearings and
bushings, resulting in accelerated wear.
The traction unit bearings and bushings that must be
lubricated are:
Steering column (Fig. 20), steering gears (2) (Under
skirt below steering sector), steering shaft (2) (Fig. 21),
lift arms (3) (Fig. 22), rear lift cylinder pivot (Fig.24),
traction pedal pivot (Fig 25).
Also, apply grease to slots in cylinder support (Fig. 26).
Quick Reference Aid
1. Engine oil level
2. Engine oil drain (17mm socket)
3. Hydraulic oil level—Center of sight glass
4. Belts (Fan/water pump, hydraulic pump)
5. Coolant level fill
6. Fuel—Diesel only
7. Grease points
8. Radiator screen
9. Air cleaner
10. Water separator/fuel filter
11. Battery
12. Tire pressure:
(.8–1.1 bar) front
(.6–.7 bar) rear
13. Fuses
Fluid
Type
SAE
Engine oil
10W30 CD
Hyd. circuit oil Mobil 424
Fuel filter
Air cleaner
Clean every 50 hours
No. 2
Fuel
Diesel
50/50
Coolant
Ethylene gly-
col water
Change Change
Capacity
Fluid Filter
3.0 l 50 hours 100 hours
12.5 l 400 hours 200 hours
200 hours
200 hours
24.5 l
Drain and flush, 2 years
4.7 l
Figure 20
Filter
Part No.
85-4930
54-0110
Perkins
130366040
93-2195
23