Toro 03422TE Operator's Manual page 12

Before Operating
fluids in Group 1.
IMPORTANT: These hydraulic fluids are specified
to allow optimal operation of the machine in a wide
range of temperatures. The group 1 fluids are
multi-viscosity hydraulic fluids that allow operation
at lower temperatures without the increased viscos-
ity associated with straight viscosity fluids.
Note: When changing from one type of hydraulic fluid
to the other, be certain you remove all the old fluid
from the system because some brands of one type are
not completely compatible with some brands of the
other type of hydraulic fluid.
IMPORTANT: Use only the types of hydraulic flu-
ids specified. Other fluids could cause system dam-
age.
Note: A red dye additive for the hydraulic system oil
is available in 20 ml bottles. One bottle is sufficient
for 15–23 liters of hydraulic oil. Order Part No. 44-
2500 from your authorized Toro distributor.
1. Position the machine on a level surface.
2. Make sure the machine has been operated so the
oil is warm. Check the oil level oil by looking in
the sight gauge. If the oil level is at the center of
the gauge, it is sufficient.
3. If the oil level is not at the center of the gauge,
remove the cap from the hydraulic oil reservoir
and slowly fill the reservoir with Mobil 424 or
equivalent hydraulic oil until the level reaches the
center of the sight gauge. DO NOT OVERFILL.
1. Hydraulic reservoir cap
2. Sight Gauge
12
Figure 6
IMPORTANT To prevent system contam-
ination, clean the top of the hydraulic oil con-
tainers before puncturing. Make sure the pour
spout and funnel are clean.
4. Install the reservoir cap. Wipe up any oil that
may have spilled.
Inspect the Fuel Filter
Inspect the fuel filter bowl daily for water or other
contaminants. If water or other contaminants are pre-
sent, they must be removed before operation.
1. Close the fuel shut-off above the filter.
2. Unscrew the nut securing the bowl to the filter
head. Remove water or other contaminants from
the bowl.
3. Inspect the fuel filter and replace it if it is dirty.
4. Install the bowl to the filter head. Make sure to
position the O-ring correctly between the bowl
mounting nut and the filter head.
1. Fuel filter
5. Open the fuel shut-off above the filter to re-fill
with fuel. Close the bleed screw.
6. Open the bleed screw on the filter mounting,
allowing the bowl to re-fill with fuel. Close the
bleed screw.
Figure 7