Inspecting Wiring And Connectors - Yamaha F150A Owner's Manual

1. Oil filler cap
Recommended engine oil:
4-stroke outboard motor oil
Replacement engine oil quantity (at peri-
odic maintenance):
Without oil filter replacement:
4.3 L (4.55 US qt, 3.78 Imp.qt)
With oil filter replacement:
4.5 L (4.76 US qt, 3.96 Imp.qt)
7. Leave the outboard motor for 5-10 min-
utes.
8. Remove oil dipstick and wipe it clean.
9. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
10. Recheck the oil level using the dipstick to
be sure the level falls between the upper
and lower marks. Consult your Yamaha
dealer if the oil level is out of specified lev-
el.
1
1. Oil dipstick
2. Lower level mark
3. Upper level mark
11. Start the engine and make sure that the
low oil pressure-alert indicator remains
off. Also, make sure that there are no oil
leaks. NOTICE: If the low oil pressure-
alert indicator comes on or if there are
oil leaks, stop the engine and find the
cause. Continued operation with a
problem could cause severe engine
damage. Consult your Yamaha dealer
if the problem cannot be located and
corrected.
[ECM01622]
12. Dispose of used oil according to local
regulations.
TIP:
For more information on the disposal of
G
used oil, consult your Yamaha dealer.
Change the oil more often when operating
G
the engine under adverse conditions such
as extended trolling.
EMU29114

Inspecting wiring and connectors

Inspect that each connector is engaged se-
G
curely.
Inspect that each ground lead is properly
G
secured.
Maintenance
3
2
ZMU07056
69