Adjusting The Anti-Scalp Rollers; Positioning The Seat; Changing The Seat Suspension - Toro Z Master Professional 7000 Series Operator's Manual

Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. After adjusting the height-of-cut, adjust the rollers by
removing the flange nut, bushing, spacer, and bolt
(Figure 19 or Figure 20).
Note: The two middle rollers will not have a spacer
(Figure 19 or Figure 20).
4. Select a hole so the anti-scalp roller is positioned to the
nearest corresponding height-of-cut desired.
5. Install the flange nut bushing, spacer, and bolt. Torque
to 40-45 ft-lb (54-61 N-m) (Figure 19 or Figure 20).
6. Repeat this adjustment on the other anti-scalp rollers.
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 19
4. Flange Nut
5. Bolt
1. Anti-scalp roller
2. Spacer
3. Bushing

Positioning the Seat

The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust, move the lever sideways to unlock seat (Figure 21).
g019754

Changing the Seat Suspension

The seat is adjustable to provide a smooth and comfortable
ride. Position the seat where you are most comfortable.
To adjust it, turn the knob in front either direction to provide
the best comfort (Figure 22).
23
Figure 20
4. Flange Nut
5. Bolt
Figure 21