Controls System Maintenance; Adjusting The Control Handle Neutral Position - Toro Z Master Professional 7000 Series Operator's Manual

Controls System
Maintenance
Adjusting the Control Handle
Neutral Position
If motion control levers do not align, or move easily into the
console notch, adjustment is required. Adjust each lever,
spring and rod separately.
Note: Motion control levers must be installed correctly.
See Installing the Motion Control Levers in the set up
instructions.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Unlatch the seat and tilt the seat forward.
4. Begin with either the left or right motion control lever.
5. Move the lever to the neutral position but not locked
(Figure 67).
6. Pull the lever back until the clevis pin (on arm below
pivot shaft) contacts the end of the slot (just beginning
to put pressure on the spring) (Figure 67).
7. Check where the control lever is relative to notch in
console (Figure 67). It should be centered allowing
lever to pivot outward to the neutral lock position.
Figure 67
1. Neutral locked position
2. Control lever
8. If adjustment is needed, loosen the nut and jam nut
against the yoke (Figure 68).
9. Apply slight rearward pressure on the motion control
lever, turn the head of the adjustment bolt in the
appropriate direction until the control lever is centered
in the neutral lock position (Figure 68).
3. Neutral position
Note: Keeping rearward pressure on the lever will
keep the pin at the end of the slot and allow the
adjustment bolt to move the lever to the appropriate
position.
10. Tighten the nut and jam nut (Figure 68).
11. Repeat for the opposite side of the machine.
1. Height-of-cut lever
2. Nut against yoke
3. Jam Nut
4. Clevis pin in slot
47
Figure 68
5. Adjustment bolt
6. Yoke
7. Spring