Manual Operation - Sandstrom S10DC14E Instruction Manual

Manual Operation

1. Open the water tank cover of the coffee maker and fill with the correct amount of
water. The water level should not exceed the maximum level indicated.
2. Add ground coffee into the filter (not included). Usually a cup of coffee needs a level
spoonful of ground coffee, but you may adjust according to your taste.
3. Place the filter with the ground coffee in the funnel and then place the funnel into
the funnel support of the coffee maker, making sure it is assembled correctly, see the
section "Funnel Assembly" for details.
4. Place the jug on the warming plate horizontally.
Press the Start button to switch the coffee maker on.
5.
• You can remove the jug, pour and serve at any time once the coffee is made. The coffee maker
will stop dripping automatically. The jug must be replaced within 15 seconds as the water is
accumulated in the funnel which may overflow if the jug is not replaced shortly.
• Do not open the tank cover while the coffee maker is brewing.
When the brewing cycle is complete, press the Stop button. You can remove the jug
6.
when brewing is finished (about one minute after the coffee stops dripping into the
jug).
The amount of coffee you get will be less than the water you have put in the tank, as some water is
absorbed by the ground coffee.
7. The coffee maker will keep your coffee hot for 40 minutes, then automatically shut off.
Always turn the coffee maker off when the coffee maker is not in use.
• Keep the lid of the jug closed when pouring.
• The brewed coffee in the jug and the grounds in the filter are very hot. Handle with care to avoid
scalding.
S10DC14E_IB_5L_140319_candice.indb 13
GB
13
20/3/14 2:30 pm