Advertisement
AFTER SALES SERVICE
Before you call the After Sales Service:
1. Re-start the cooktop, to check whether
correct operation has been restored.
2. If the malfunction persists, call the After Sales
Service.
Give the following information:
• type of malfunction;
• model of cooktop;
• service number (i.e., the number that
follows the word SERVICE on the rating
plate under the cooktop and on the
guarantee paper);
• your complete address;
• your telephone number and area code.
INSTALLATION
Technical information for the Installer
This cooking hob can be embedded in a worktop 20 to
50 mm thick.
If another appliance is not fitted under the cooking hob,
insert a separator panel, at a distance of at least 90 mm
from the cooking hob bottom.
• If a vertical piece of furniture is installed, there must be
a gap of at least 100 mm between it and the edge of the
cooking hob.
Installation of cooking hob
• Apply the supplied gasket to the cooking hob (unless it
has already been fitted), after having cleaned its surface
as shown in the figure.
A - If the worktop is made out of wood, use the springs supplied.
1. Fit the 4 springs
2. Make an opening in the worktop, respecting the
dimensions indicated in the enclosed product description
sheet.
3. Install the cooking hob in the worktop.
B - If the worktop is made out of marble or other materials
(plastics, ceramics or stone), the cooking hob must be
fixed by means of brackets
After-Sales Service (code 4819 310 18528).
1. Align the brackets with the bores and fix them with the
screws.
2. Make an opening in the worktop, respecting the
dimensions indicated in the product description sheet.
3. Install the cooking hob in the worktop.
• Before installing the cooking hob, remove the plastic
film that protects it, if present.
• Installation must comply with current local safety
regulations.
into the relevant seat under the box.
, to be ordered from the
If any repairs are required, please contact an
authorised After-Sales Service, as indicated in
the warranty.
In the unlikely event that an operation or repair is
carried out by an unauthorised technician,
always request a certification of the job carried
out and insist on the use of original spare parts.
Failure to comply with these instructions may
compromise the safety and quality of the
product.
47
Advertisement
