Fuel Filter; Transaxle Fluid - Toro 74105 Operator's Manual

Maintenance

Fuel Filter

Replace the fuel filter after every 200 operating hours
or yearly, whichever occurs first.
Replacing the Fuel Filter
Never install a dirty filter if it is removed from the
fuel line.
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
"OFF" to stop the engine. Remove the key.
2. Close fuel shut–off valve at fuel tank (Fig. 24).
3. Squeeze the ends of the hose clamps together
and slide them away from the filter (Fig. 25).
4. Remove the filter from the fuel lines.
5. Install a new filter and move the hose clamps
close to the filter.
6. Open fuel shut-off valve at fuel tank (Fig. 24).
Figure 25
1. Hose clamp
2. Fuel line
28
1
m–1217
2
3. Filter

Transaxle Fluid

Service Interval/Specification
Check fluid level initial use and after every 100 hours
or yearly whichever comes first. Always keep the
fluid level at the full level when the transaxle is cold.
The transaxle is a sealed system and no changing of
the fluid is required.
Fluid Type: Mobilube 424
Quantity: 3-1/2 qt (3.3 l)
Checking Fluid Level
1. Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2. Clean around the fluid reservoir (Fig. 26) so
level is clearly visible and so dirt cannot fall into
the reservoir if fluid is added.
3. When transaxle is cold add oil to "Full Cold"
line on reservoir (Fig. 26).
IMPORTANT: Do not fill above the full cold
line as fluid may overflow.
1
Figure 26
1. Fluid reservoir
2
1243
2. Full cold level