Adjusting The Anti-Scalp Rollers - Toro 74952 Operator's Manual

Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inch) cutting-height position); refer to
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height of cut desired, and insert the pin
26).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 26
1. Deck-lift pedal
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position,
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers as shown in
Figure 28, and Figure
Figure
(Figure 26).
(Figure
3. Transport lock
Figure
29.
26.
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
1. Anti-scalp roller
2. Spacer
3. Bushing
27,
25
Figure 27
4. Flange nut
5. Bolt
Figure 28
3. Flange nut
4. Bolt
Figure 29
4. Flange nut
5. Bolt