Adjusting The Flow Baffle; Positioning The Flow Baffle - Toro 30366 Operator's Manual

To adjust the rear (internal) rollers
1. Remove the lock nuts securing the roller shafts to the
underside of the deck.
Figure 15
1. Internal rollers
2. Slide the shafts out of the lower bracket holes, align the
rollers with the top holes and install the shafts.
3. Install the lock nuts to secure the assemblies.

Adjusting the Flow Baffle

The mower discharge flow can be adjusted for different
types of mowing conditions. Position the cam locks and
baffle to give the best quality of cut.
1. To adjust the cam locks, swing the lever up to loosen
the cam lock (Fig. 16).
1
4
Figure 16
1. Cam lock
2. Lever
3. Rotate cam to increase or
decrease locking
pressure
(Fig. 15)
1
1
2
3
m–6823
4. Slot
16
2. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
3. Swing the lever back over to tighten the baffle and cam
locks.
4. If the cams do not lock the baffle into place or it is too
tight, loosen the lever and then rotate the cam lock.
Adjust the cam lock until the desired locking pressure is
achieved.

Positioning the Flow Baffle

The following figures are only recommendations for use.
Adjustments will vary by grass type, moisture content, and
height of grass.
Note: If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for this
position is a follows.
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the mower.
Full Rearward Position
Figure 17
m–6829