Adjusting The Skids; Adjusting The Anti-Scalp Rollers; Adjusting The Rollers - Toro 30366 Operator's Manual

Adjusting the Skids

The skids should be mounted in the lower position when
operating in height of cuts greater than 2-1/2 inches
(64 mm) and in the higher position when operating in
height of cuts lower than 2-1/2 inches (64 mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Fig. 11).
Figure 11
1. Skid
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. After adjusting the height-of-cut, adjust the rollers by
removing the flange nut, bushing, spacer, and bolt
(Fig. 12).
5
3
Figure 12
1. Anti–scalp roller
2. Spacer
3. Bushing
1
1
2
1
4. Flange Nut
5. Bolt
15
2. Select a hole so the anti–scalp roller is positioned to the
nearest corresponding height-of-cut desired (Fig. 13).
Figure 13
3. Install the flange nut, bushing, spacer, and bolt. Torque
to 40–45 ft–lb (54–61 N⋅m) (Fig. 12).

Adjusting the Rollers

Note: If the cutting unit is to be used in the 1 or 1-1/2 in.
(25 or 38 mm) height-of-cut setting, the cutting unit rollers
must be repositioned in the top bracket holes.
To adjust the front rollers
1. Remove the screw and nut securing the roller shaft to
the deck bracket .
2
1
Figure 14
1. Roller
2. Slide the shaft out of the lower bracket holes, align the
roller with the top holes, and install the shaft.
3. Install the screw and nut to secure the assemblies.
(Fig. 14)
2. Roller shaft