Installation Of Indoor Unit - International comfort products DLFBB09K Owner's Manual

Installation of indoor unit

Step one: choosing the installation location
Step two: install wall-mounting frame
1. Hang the wall-mounting frame on the wall; adjust it in horizontal position with the
anchors in the holes.
3. Secure the wall-mounting frame on the wall with tapping screws and
anchors are
Step three: open piping hole
1. Choose the position of the piping hole according to the direction of the outlet pipe. The
position of the piping hole should be a little lower than the wall-mounted frame,
as shown as below.
18K:
Wall
Mark in the middle of it
Space
to the
wall
above
6 in (150 mm)
Left
3 4 / n i 7 ( 0 m m )
Rear piping hole
2. Open a piping hole with the diameter o
hole on the wall slightly
20
anchors
、12K:
Wall
Mark in the middle of it
Space
to the
wall
above
6 in (150 mm)
Left
2 1/6 in (55mm)
Rear piping hole
24K:
Wall Wall
Level meter
Space
to the
wall
above
6 in (150 mm)
Right
3 4 / n i 7 ( 0 m m )
Rear piping hole
position. To drain smoothly, slant the piping
Specifications are subject to change without notice
place
.
Wall
Level meter
Space
to the
wall
above
6 in (150 mm)
Right
2 1/6 in (55mm)
Rear piping hole
Mark in the middle of it Level meter
Space
to the
wall
above
6 in (150 mm)
Left
3/4 in (70mm)
Rear piping hole
2 1/6 in (55mm) 2 3/4 in (70mm)
Wall
Space
to the
wall
above
6 in (150 mm)
Right
3/4 in (70mm)
Rear piping hole
421 02 9240 00