Onkyo TX SR607 Instruction Manual page 76

Advanced Setup—Continued
CinemaFILTER
With the CinemaFILTER, you can soften overly bright movie soundtracks, which are typically mixed for reproduction
in a movie theater.
CinemaFILTER can be used with the following listening modes: Dolby Digital, Dolby Digital EX, Dolby Pro Logic
IIx Movie, Dolby Pro Logic II Movie, DTS, DTS-ES, DTS Neo:6 Cinema, DTS 96/24, and Neo:6.
Cinema Fltr
Note:
The CinemaFILTER may not work when used with certain input sources.
Audyssey Dynamic Volume™
Dyn Vol
Music Optimizer
The Music Optimizer function enhances the sound quality of compressed music files. Use it with music files that use
"lossy" compression, such as MP3. The setting is stored individually for each input selector.
M.Optimizer
Note:
The Music Optimizer function only works with PCM digital audio input signals with a sampling rate below 48kHz
and analog audio input signals. The Music Optimizer is disabled when the Direct or Pure Audio listening mode is
selected.
Speaker Layout
You can select the priority of the use of SurrBack speakers or FrontHigh speakers.
SpLayout
Notes:
• If the "Speaker Type" setting is set to "Bi-Amp" (page 43), or Powered Zone 2 is being used (page 86), this setting
cannot be selected.
• When the listening mode that doesn't correspond to the switch of the speakers is used, the setting cannot be
selected.
• This setting can also be selected on the remote controller by using [GUIDE/TOP MENU] button.
Speaker Levels
You can adjust the volume of each speaker while listening to an input source.
These temporary adjustments are cancelled when the AV receiver is set to Standby.
Subwfr (Subwoofer) –15 dB to +12 dB (default: 0 dB)
Center
Notes:
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to "No" or "None" in the Speaker Configuration cannot be adjusted (See page 70).
• This setting is not available when the Direct or Pure Audio listening mode is used with an analog input signal.
A/V Sync
When using progressive scanning on your DVD player, you may find that the picture and sound are out of sync. With
this setting, you can correct this by delaying the audio signals.
A/V Sync
Note:
This setting is not available when the Direct or Pure Audio listening mode is used with an analog input signal.
76
Off: CinemaFILTER off (default).
On: CinemaFILTER on.
See "Dynamic Volume" of "Audio Adjust" on page 73
Off: Music Optimizer off (default).
On: Music Optimizer on.
SurrBk: The sound from surround back speakers is output by priority.
FrontH: The sound from front high speakers is output by priority.
–12 dB to +12 dB (default: 0 dB)
0 ms to 100 ms in 10 ms steps