Before Using The T-4555; Installing The Batteries; Aiming The Remote Controller - Onkyo T T-4555 Instruction Manual

Before Using the T-4555

Installing the Batteries

1
Open the battery compartment, as shown.
2 Insert the two supplied batteries (AA) in
accordance with the polarity diagram
inside the battery compartment.
3
Close the battery compartment.
Notes:
• If the remote controller doesn't work reliably, try
replacing the batteries.
• Don't mix new and old batteries or different types of
batteries.
• If you intend not to use the remote controller for a
long time, remove the batteries to prevent damage
from leakage and corrosion.
• Flat batteries should be removed as soon as possible
to prevent damage from leakage and corrosion.

Aiming the Remote Controller

When using the remote controller, point it toward the
T-4555's remote control sensor, as shown below.
Remote control sensor
30˚
30˚
Notes:
• The remote controller may not work reliably if the
T-4555 is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in
mind when installing.
• If another remote controller of the same type is used
in the same room, or the T-4555 is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don't put anything, such as a book, on the remote
controller because the buttons may be pressed inad-
vertently, thereby draining the batteries.
• The remote controller may not work reliably if the
T-4555 is installed in a rack behind colored glass
doors. Keep this in mind when installing.
• The remote controller will not work if there's an
obstacle between it and the T-4555's remote control
sensor.
T-4555
9