Safety Symbols - Circuit-test DMR-1500 User Manual

• When ʻBATʼ appears on the display, change both batteries to
achieve more accurate readings.
• Turn the meter off and disconnect any load before removing the
batteries.
• Do not operate the unit unless the case is completely closed.
• When using the test probes always keep fingers behind the finger
guards. Never touch the exposed probe tip.
• Always inspect the instrument, test leads and other accessories for
damage prior to use.

SAFETY SYMBOLS

Safety symbols and special annunciators on the meter and in this manual
indicate cautions and warnings of important operational procedures that
must be followed to ensure personal and product safety.
This symbol indicates a General Warning. When adjacent to a
terminal or operating device indicates that the operator must
refer to an explanation in the Operating Instructions.
This symbol indicates that the terminal(s) so marked must not
450V
MAX
be connected to a circuit point at which the voltage with respect
to ground exceeds 450V AC/DC.
This symbol adjacent to one or more terminals indicates them
as being associated with ranges that may in normal use, be
subjected to particularly hazardous voltages. For maximum
safety, the meter and its test leads should not be handled when
these terminals are energized.
– 3 –