Digital Input Signal Formats - Onkyo TX-SR504E Instruction Manual

Advanced Setup—Continued
4
Use the Left and Right [
buttons to adjust the speaker
level, and use the Down [
ton to select the next speaker.
The levels can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
5
Repeat step 4 so that the level of
the test tone coming from each
speaker is the same.
Speakers that you set to No or None in
the Speaker Configuration (page 34) do
not output the test tone.
6
Press the [SETUP] button.
Setup closes.
Don't forget to turn down the volume if
you turned it up while setting the levels.
SETUP
Note:
• A quick way to adjust the speaker levels is to press the
remote controller's [TEST TONE] button to turn on
the test tone, use the [LEVEL–] and [LEVEL+] but-
tons to adjust the levels, and use the [CH SEL] button
to select the speakers.

Digital Input Signal Formats

]/[ ]
The following table shows the display indicator for each
] but-
digital signal format.
Format
Dolby Digital
DTS
PCM
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can specify the signal format as either PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or reversing
a DTS CD, try the DTS setting.
STANDBY/ON
STANDBY
PHONES
1
Press and hold the AV receiver's [DIGITAL
INPUT] button for about 3 seconds.
2
While "Auto" is displayed (about 3 sec-
onds), press the [DIGITAL INPUT] button
repeatedly to select: PCM, DTS, or Auto.
PCM: Only PCM format input signals will be
heard. If the input signal is not PCM, the PCM
indicator will flash and there will be no sound.
DTS: Only DTS format input signals will be
heard. If the input signal is not DTS, the DTS
indicator will flash and there will be no sound.
Auto (default): The format is detected automati-
cally. If no digital input signal is present, the
corresponding analog input is used instead.
Display
PCM
TUNING
MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 TAPE TUNER C D RETURN
VCR
SPEAKERS
DIGITAL TUNING
A B TONE STEREO LISTENING MODE DISPLAY INPUT DIMMER MEMORY MODE
CLEAR
DIGITAL INPUT
MASTER VOLUME
PRESET
ENTER
SETUP
VIDEO 3 INPUT
VIDEO L AUDIO R
57