Phil & Teds Evolution BS01-B Instructions Manual page 18

Installation in the vehicle /17
4.2 Installation of Group I for
children 9-18kg.
• Adjust the baby car seat into the sleeping
position (3-B).
• Take the lower shaft out of the seat, then pull
the seat back (4-G).
• Install the safety belt through the seat back
from the middle of top and fix into the buckle
on the car seat (4-H).
• The seat will be fixed by the belt in two
directions. Route shoulder belt through both
lock-off devices, and lap belt through the
lower red guides. Tighten car belt between
each guide, clamp using lock-off devices (4-I)
• Put the seat body back. Insert the lower shaft
and lock the shaft safely (4-J).
• Pull out a small portion of the upper metal
shaft, let the shoulder belt go below of the
upper metal shaft, and secure the upper metal
shaft (4-K).