Battery Care - Toro 03540 Operator's Manual

tie rod.
3. Rotate tie rod(s) to move the front of the tire
inward or outward.
4. Tighten the tie rod clamps when adjustment is
correct.

BATTERY CARE

IMPORTANT: Before welding on the machine,
disconnect both cables from the battery,
disconnect both wire harness plugs from the
electronic control unit and the terminal
connector from the alternator to prevent damage
to the electrical system.
CAUTION
Wear safety goggles and rubber gloves when
working with electrolyte. Charge the battery in a
well ventilated so gases produced while charging
can dissipate. Since the gases are explosive, keep
open flames and electrical sparks away from the
battery; do not smoke. Nausea may result if the
gases are inhaled. Unplug the charger from the
electrical outlet before connecting to, or
disconnecting charger leads from battery posts.
FUSES (Fig. 57)
There are four fuses in the machines electrical
system. They are located below control panel.
Figure 57
CUTTING UNIT MAINTENANCE
DANGER
Reels may stall while backlapping. Do not attempt
to restart reels by hand or while backlapping. Stop
the engine and turn the height of cut knob one
position toward "A".
BACKLAPPING
Note: When backlapping, the front units all operate
together, and the rear units operate together.
1. Position the machine on a level surface, lower
the cutting units, stop the engine, engage the
parking brake, and move the Enable/Disable
switch to the Disable position.
2. Unlock and raise the seat to expose controls.
3. Make initial reel-to-bedknife adjustments
appropriate for backlapping on all cutting units
that are to be backlapped.
4. Start the engine and run at idle speed.
Maintenance
41