Onkyo TX SR805 Instruction Manual page 87

Advanced Setup—Continued
5 Use the Up and Down [
buttons to select "Front," and
then use the Left and Right
ENTER [ ]/[ ] buttons to select a
crossover frequency.
Note:
• Fixed at Full Band if Subwoofer
(step 4) is set to No.
ENTER
6
Use the Up and Down [
buttons to select "Center," and
then use the Left and Right
ENTER [ ]/[ ] buttons to select a
crossover frequency.
If no center speaker is connected, select
None.
Notes:
• Cannot set if Speaker Type is set to
ENTER
BTL (page 45).
• Cannot select Full Band if Front
(step 5) is set to anything other than
Full Band.
7 Use the Up and Down [
buttons to select "Surround," and
then use the Left and Right
ENTER [ ]/[ ] buttons to select a
crossover frequency.
If no surround left and right speakers
are connected, select None.
Notes:
• Cannot set if Speaker Type is set to
ENTER
BTL (page 45).
• Cannot select Full Band if Front
(step 5) is set to anything other than
Full Band.
]/[ ] 8
ENTER
ENTER
]/[ ]
9
ENTER
ENTER
]/[ ]
Use the Up and Down [
buttons to select "Surr Back,"
and then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
If no surround back speakers are con-
nected, select None.
Notes:
• Cannot be set if Speaker Type is set
to Bi-Amp or BTL (page 45), Sur-
round is set to None (step 7), or Pow-
ered Zone 2 is being used
(page 103).
• Cannot select Full Band if Surround
(step 7) is set to anything other than
Full Band.
Use the Up and Down [
buttons to select "Surr Back Ch,"
and then use the Left and Right
[ ]/[ ] buttons to select:
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right)
surround back speakers are
connected.
Note:
• Cannot be set if Speaker Type is set
to Bi-Amp or BTL (page 45), Surr-
Back is set to None (step 8), or Pow-
ered Zone 2 is being used
(page 103).
Continue with step 10 on the next page.
]/[ ]
]/[ ]
87