Controlling Other Components; Entering Remote Control Codes - Onkyo TX SR805 Instruction Manual

Controlling Other Components

You can control your other components, including those
made by other manufacturers, with the remote controller.
This section explains how to:
• Enter the remote control code for a component that
you want to control: DVD, TV, VCR, etc.
• Learn commands directly from another component's
remote controller (see page 111).
• Program the MACRO buttons to perform a sequence
of up to eight remote control actions (see page 112).

Entering Remote Control Codes

To control another component, you must first enter that
component's remote control code to a REMOTE MODE
button. You'll need to enter a code for each component
that you want to control.
STANDBY
Number
buttons
REMOTE
MODE
DIMMER
PREV
CH
DISPLAY
1
Look up the component's remote
control code in the separate
Remote Control Codes list.
The codes are organized by category.
108
Remote
indicator
ON STANDBY
TV
INPUT
TV
DVD VCR/DVR CBL/SAT
+
1 2 3
TV CH
GAME/TV AUX 1 AUX 2
-
4 5 6
TAPE TUNER CD
7 8 9
TV VOL
PHONO D. TUN
+10 0 CLEAR
--/--- 10 11 12
INPUT SELECTOR
MACRO
1 2 3
ZONE 3
REMOTE MODE
DVD VCR CD ZONE 2
CDR/MD
RECEIVER
TV CABLE DOCK RECEIVER
SAT TAPE/AMP
SLEEP
+
CH
ENTER VOL
DISC
ALBUM
-
MUTING
REC PLAYLIST RANDOM
LISTENING MODE
STEREO SURR
REPEAT AUDIO SUBTITLE PLAY MODE
PURE A DIRECT THX ALL ST
TEST TONE CH SEL LEVEL- LEVEL+
OPEN/CLOSE VIDEO OFF
AUDIO SEL L NIGHT Re-EQ
VCR VCR DVD DVD HDD HDD
RC- 690 M
2
REMOTE MODE
DVD VCR
CD
TV
CDR/MD
CABLE
SAT
STANDBY
3
DVD VCR/DVR CBL/SAT
1 2
GAME/TV AUX 1 AUX 2
4 5
TAPE TUNER
7 8
0
I
4
Notes:
• Remote control codes cannot be entered for the
[RECEIVER] and [DOCK] REMOTE MODE but-
tons.
• The remote control codes provided are correct at the
time of printing but subject to change.
• The DOCK remote mode can only be used with
the Onkyo RI Dock at this time.
• The [DVD] and [CD] REMOTE MODE buttons
are preprogrammed for use with Onkyo DVD
players and CD players, respectively.
• To control another manufacturer's CD recorder or
MD recorder, enter the appropriate remote control
code to the [CD] REMOTE MODE button.
While holding down the REMOTE
MODE button to which you want
to enter the code, press the
[STANDBY] button.
The Remote indicator lights up.
Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
3
The Remote indicator flashes twice.
6
CD
9
Press the REMOTE MODE button
again to select the remote con-
troller mode, point the remote
controller at the component, and
check the operation.
If the remote controller doesn't work as
expected, and several remote codes are
listed, try each one in turn and use the
one that works best.