Adjusting The Rollers - Toro 30366 Operator's Manual

reverse the machines direction to pull any clippings
away from the wheel/fork area.
3. Remove the tensioning cap from the spindle shaft
(Figure 6) and slide the spindle out of the castor
arm. Put the 2 shims (1/8 inch) onto the spindle
shaft as they were originally installed. These shims
are required to achieve a level across the entire width
of the cutting units. Slide the appropriate number
of 1/2 inch spacers onto the spindle shaft to get the
desired height-of-cut; then slide the washer onto
the shaft.
Refer to Figure 7 to determine the combinations
of spacers for the setting.
4. Push the castor spindle through the castor arm.
Install the shims (as they were originally installed)
and the remaining spacers onto the spindle shaft.
Install the tensioning cap to secure the assembly.
5. Remove the hair pin and clevis pin securing the
height of cut collar to the height of cut rod on the
rear of the cutting unit (Figure 8).
Figure 8
1. Height-of-cut rod
2. Height-of-cut collar
6. Align the height-of-cut collar to the desired
height-of-cut holes on the height of cut rod
(Figure 8 and Figure 9).
7. Secure the adjustment with the clevis pin and hair
pin.
Note: Position the head of the clevis pin toward
the front of the deck, if possible.
Note: When using 1 inch (25 mm), 1-1/2 inch (38
mm), or occasionally 2 inch (51 mm) height–of–cut,
move the skids and roller to the highest holes.
3. Clevis pin and hairpin
cotter

Adjusting the Rollers

Note: If the cutting unit is to be used in the 1 or 1-1/2
in. (25 or 38 mm) height-of-cut setting, the cutting unit
rollers must be repositioned in the top bracket holes.
To adjust the front rollers (Figure 10).
1. Remove the screw and nut securing the roller shaft
to the deck bracket.
1. Roller
2. Slide the shaft out of the lower bracket holes, align
the roller with the top holes, and install the shaft.
3. Install the screw and nut to secure the assemblies.
To adjust the rear (internal) rollers (Figure 11)
13
Figure 9
Figure 10
2. Roller shaft