Table of Contents
Advertisement
Cleaning and Storage
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to Off. Remove the
key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine cylinder head fins and blower
housing.
Important
You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, engine, hydraulic pumps, and motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner, page 36.
4. Grease and oil the machine; refer to Greasing and
Lubrication, page 41.
5. Change the crankcase oil; refer to Servicing the
Engine Oil, page 37.
6. Change the hydraulic filter; refer to Servicing the
Hydraulic System, page 43.
7. Check the tire pressure; refer to Checking the Tire
Pressure, page 43.
8. Charge the battery; refer to Servicing the Battery,
page 54.
9. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with a
garden hose.
Note: Run the machine with the PTO engaged and the
engine at high idle for 2 to 5 minutes after washing.
10. Check the condition of the blades; refer to Servicing
the Cutting Blades, page 34.
11. Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most effective
when mixed with fresh fuel and used at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Stop the engine, allow it to cool, and drain the fuel
tank; refer to Draining the Fuel Tank, page 41.
D. Restart the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per local
codes.
Important
Do not store stabilizer/conditioned fuel
over 90 days.
12. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
13. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
14. Store the machine in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it out of reach of children or other unauthorized
users. Cover the machine to protect it and keep it
clean.
58
Advertisement
Table of Contents
