Adjusting The Caster Pivot Bearing; Checking The Wheel Hub Slotted Nut; Leveling The Mower At Three Positions - Toro 74268TE Operator's Manual

With 152cm turbo force side discharge mower
Hide thumbs Also See for 74268TE:
Table of Contents

Advertisement

2
1
Figure 62
1. Pump rod
2. Turn this way to track left
Adjusting the Caster Pivot
Bearing
Check after every 500 operating hours or at storage,
whichever comes first.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the dust cap from the caster and tighten the
locknut (Fig. 63).
4. Tighten until the spring washers are flat and then back
off 1/4 turn to properly set the preload on the bearings
(Fig. 63).
Important
Make sure that the spring washers are
installed correctly as shown in Figure 63.
Figure 63
1. Spring washers
2. Locknut
3
4
m–6280
3. Tracking knob
4. Turn this way to track right
3
2
1
M–4640
3. Dust cap
48
Checking the Wheel Hub
Slotted Nut
Check after every 500 operating hours.
The slotted nut needs to be torqued to 125 ft-lb (170 N m).
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the cotter pin.
4. Torque the slotted nut to 125 ft.-lb. (170 N m)
(Fig. 64).
5. Check the distance from the bottom of the slot in the
nut to the inside edge of the hole. Two threads or less
should be showing (Fig. 64).
6. If more than two threads are showing, remove the nut
and install the washer between the hub and nut
(Fig. 64).
7. Torque the slotted nut to 125 ft-lb (170 N m) (Fig. 64).
8. Tighten the nut until the next set of slots line up with
the hole in the shaft (Fig. 64).
9. Install the cotter pin.
4
2
Figure 64
1. Slotted nut
2. Two threads or less
showing
Leveling the Mower at Three
Positions
Important
There are only three measuring positions
needed to level the mower.
Setting Up the Machine
1. Position mower on a flat surface.
2. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
1
3
m–4638
3. Hole in threaded rod
4. Washer (if needed)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z597–d z master

Table of Contents