Washing The Underside Of The Mower - Toro 71242 Operator's Manual

Washing the Underside of the
Mower
After each use wash the underside of the mower to prevent
grass buildup for improved mulch action and clipping
dispersal.
1. Park the machine on a hard, level surface, disengage the
PTO, stop the engine, and remove the ignition key.
2. Attach the coupling (not included) to the mower
washout fitting and turn the water on high (Fig. 53).
Note: Spread petroleum jelly on the washout fitting o-ring
to make the coupling slide on easier and protect the o-ring.
Figure 53
1. Washout fitting
2. Coupling (not included)
3. Lower the mower to the lowest height of cut.
4. Sit on the seat and start the engine. Engage the PTO and
let the mower run for one to three minutes.
5. Disengage the PTO, stop the engine, and remove the
ignition key.
6. Turn the water off and remove the coupling from the
washout fitting and hose.
7. Run the mower again for one to three minutes to
remove excess water.
3
2
1
m–2921
3. Hose
36
Warning
A broken or missing washout fitting could expose
you and others to thrown objects or blade contact.
Contact with blade or thrown debris contact will
cause injury or death.
Replace broken or missing washout fitting
immediately, before using mower again.
Plug any hole(s) in mower with bolts and
locknuts.
Never put your hands or feet under the mower
or through openings in the mower.