Testing The Safety System; Pushing The Machine By Hand - Toro 71242 Operator's Manual

1
Figure 12
1. Operating-in-reverse light
4. Shift into reverse and complete your task.
5. Stop the PTO of the engine to activate the interlock.
6. Remove the KeyChoice key and put it in a safe place
out of reach of children.

Testing the Safety System

Caution
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
Do not tamper with the interlock switches.
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Test the safety system before you use the machine each
time. If the safety system does not operate as described
below, have an Authorized Service Dealer repair the safety
system immediately. While sitting in the seat, perform the
following checks:
1. Set the parking brake. Move the PTO to Engaged. Turn
the ignition key to Start; the engine should not crank.
2. Move the PTO to Disengaged and release the parking
brake. Turn the ignition key to Start; the engine should
not crank.
3. Set the parking brake and move the PTO to Disengaged.
Start the engine. While the engine is running, release
the parking brake and rise slightly from the seat; the
engine should stop.
4. Put the PTO lever in the Disengage position, the
traction control pedal in neutral, and set the parking
brake. Start the engine. While the engine is running,
move the PTO lever to the Engage position and move
the traction control pedal to reverse. The engine should
stop.
5. Put the PTO lever in the Disengage position, the
traction control pedal in neutral, and set the parking
brake. Start the engine. Move the PTO lever to the
Engage position and turn the KeyChoice key and
release it. The operating-in-reverse warning light should
illuminate. Move the PTO lever to the Disengage
position and the operating-in-reverse warning light
should turn off.
m–1863

Pushing the Machine by Hand

Important
tow the machine because transaxle damage may occur.
To Push the Machine
1. Disengage the PTO, stop the engine, and remove the
ignition key.
2. Pull the drive control out to the Push position. This
disengages the drive system and allows the wheels to
turn freely (Fig. 13).
To Operate the Machine
Push the drive control in to the Operate position. This
engages the drive system (Fig. 13).
Note: The machine will not drive unless the drive control is
in the Operate position.
1. Operate position
17
Always push the machine by hand. Never
2
Figure 13
2. Push position
1
m–4974