Cleaning; Cleaning Under The Mower; Waste Disposal - Toro Z Master 74925TE Operator's Manual

6 2
1
g015594
Figure 97
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place spacer and spring onto grass deflector. Place
one J end of spring behind deck edge.
Note: Make sure one J end of spring is installed
behind deck edge before installing the bolt as shown
in Figure 97.
3. Install bolt and nut. Place one J hook end of spring
around grass deflector (Figure 97).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
4
7
3
5
5. Spring installed
6. Grass Deflector
7. J hook end of spring

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the transport position.

Waste Disposal

Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
63