Toro Z Master 74925TE Operator's Manual page 58

10. Fine-tune the adjustment nut on the front deck lift
assembly by turning it (Figure 86).
To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
2
1
G012430
1. Adjustment nut
2. Jam Nut
11. If the front deck links do not have enough adjustment
to achieve accurate cut height , the single point
adjustment can be utilized to gain more adjustment.
12. To adjust the single point system, loosen the two
bolts at the bottom of the height of cut plate. Refer
to Figure 87.
3 4
2 1
Figure 86
3. Rear deck adjustment
4. Front deck adjustment
1. Bolts at the bottom of the height-of-cut plate
13. If the deck is too low, tighten the single point
adjustment bolt by rotating it clockwise. If the deck
is too high, loosen the single point adjustment bolt
by rotating it counterclockwise (Figure 88).
Note: Loosen or tighten the single point adjustment
bolt enough to move the height-of-cut plate
mounting bolts at least 1/3 the length of the available
travel in their slots. This will regain some up and
down adjustment on each of the four deck links.
1. Single point adjustment bolt
14. Tighten the two bolts at the bottom of the height of
cut plate (Figure 87). Torque to 27-33 ft-lb (37-45
N-m).
58
Figure 87
g017036
Figure 88
1
g017029