Renault 2016 Duster Owner's Manual page 100

TYRE PRESSURE LOSS WARNING
SYSTEM A (cntd.)
Resetting the standard level for the
tyre pressures
This should be done:
– after each reinflation or readjustment
of the pressure of one of the tyres;
– when the standard tyre pressure
needs to be changed to adapt to
usage conditions (empty, carrying a
load, motorway driving, etc.);
– after changing a wheel;
– after using the tyre inflation kit;
– after changing wheels around.
It should always be done after checking
the tyre pressure of all four tyres when
cold.
Tyre pressures must correspond to the
current usage of the vehicle (empty,
carrying a load, motorway driving, etc.).
2.24
ENG_NU_1079-6_H79Ph2_Dacia_2
Jaune Noir Noir texte
(3/7)
Resetting procedure
With the ignition on:
– repeatedly press the button 3 to
select the "SEt tP" function on the
display 2;
– press and hold (around 3 seconds)
the button 3 to start initialisation. The
flashing, lasting around five seconds,
followed by a constant display of the
message «SEt tP" indicates that the
reset request for the tyre pressure
reference value has been taken into
account.
Reinitialisation is carried out after a few
minutes' driving.
Avertisseur de perte de pression des pneumatique (H79 Ph2 - Dacia)
Display
2
Inflate tyres and SEt tP
The warning light
flashing).
This indicates that at least one tyre is
flat or punctured.
3
In the event of a flat tyre, inflate the rel-
evant tyre.
In the event of a puncture, change the
tyre or consult an authorised dealer.
Check and readjust the pressure of the
four tyres when cold, and launch the
reset of the tyre pressure reference
value.
Warning light
launching the reinitialisation of the tyre
pressure reference value.
The sudden loss of pressure in a
tyre (burst tyre, etc.) cannot be de-
tected by the system.
ENG_UD38382_3
comes on (not
goes out after