Table of Contents
Advertisement
2 Installation and Setup
2.3 GigE Connections and SkLineScan Software Installation
This section is a quick reference for installing the SkLineScan adjustment and configuration software and to set
up the Gigabit Ethernet network adapter. SkLineScan and the SkLineScan manual is provided for download on the
Schäfter + Kirchhoff website under http://www.sukhamburg.com/support.html. It is also part of the fee-based
software development kit SK91GigE-WIN.
Step 1: Install SkLineScan
Step 2: If the Gigabit network interface controller
(NIC) has an INTEL PRO/1000 chip then
install the High Performance Driver
SkLineScan Installation
Prior to the installation, power on the PC (not the camera) and unpack the downloaded zip-file to a temporary
folder. Alternatively, if your installation medium is a CD, insert the disk to the drive.
The autostart function may launch the setup program automatically from CD. Otherwise, look for one of these
installation files:
SkLineScan-GigE-Win_x64.msi
SkLineScan-GigE-Win_x86.msi
Then start the applicable installation file manually. This will set up the Schäfter + Kirchhoff SkLineScan camera
control and adjustment tool as well as the Pleora Network Driver Installation Tool.
Network Driver Installation
High Performance Driver for Intel PRO/1000 Chip
If the line scan camera is connected to a network interface card (NIC) with Intel PRO/1000 chip, then
•
install the "High Performance IP Device Driver". This is the recommended system configuration for
optimum performance.
Open the program menue
manually:
•
For 64-bit operating systems choose
"Driver Installation x64".
•
For 32-bit systems (Windows 7 32-bit, XP) use
"Driver Installation x86".
The eBUS driver installation tool window
available network adapters and the currently installed network drivers in the system.
B
Plug in the CAT6 network cable to the camera and switch on the power supply. Then restart the system and check
the driver installation with the driver installation tool
C
The High-Performance driver is installed, further network adjustments are not required.
© 2015
Schäfter + Kirchhoff GmbH • Hamburg
and start the network driver installation
A
will show up to list the
B
SK7500GTO-XL Instruction Manual (11.2015)
Step 3: Plug in the CAT6 network cable to the
camera and switch on the power supply.
Step 4: Check the network connection.
Step 5: Start the SkLineScan program.
SK91GigE-Win_x64.msi
SK91GigE-Win_x86.msi
A
.
C
Start Driver Installation Tool
from Start Menue
9
Advertisement
Table of Contents
