Table of Contents
Advertisement
4 Advanced SkLineScan Software Functions
4.1 Camera Control by Commands
In addition to user dialog inputs, the SkLineScan software also provides the option to adjust any camera settings,
such as gain, offset, trigger modes, by sending control commands directly.
Similarly, current parameters, as well as specific product information, can be read from the camera using the request
commands. All set and request commands are listed in the tables below.
•
The commands are entered in the 'Input' field in the 'Camera Control' section of the "Camera Gain/Offset
Control" user dialog, [Shift+F4].
•
In the 'Output' field either the acknowledgement of the set commands (0 = OK, 1 = not OK) or the return values
of the request commands are output.
The parameter settings are stored in the non-volatile flash memory of the camera and, thereby, are available for
subsequent use and a rapid start-up, even after a complete shut down or loss of power.
Gain/Offset Control dialog: Camera Control input and output in the right section
20
SK7500GTO-XL Instruction Manual (11.2015)
4 Advanced SkLineScan Software Functions
Schäfter + Kirchhoff GmbH • Hamburg
© 2015
Advertisement
Table of Contents
