Sklinescan Start-Up; Camera Setup; Initial Function Test - Schäfter+Kirchhoff SK7500GTO-XL Instruction Manual

Standard GigE Network Adapters
• For non-Intel PRO/1000 network adapters
install the driver recommended by the
manufacturer.
!
This kind of GigE network adapters do require
additional setup. These settings should be
optimized during installation in the Advanced
Properties tab
D
Jumbo Frames
Receive Descriptors
Interrupt Moderation Rate
Energy Efficient Ethernet
LAN adapters for GigE cameras that do not
work with the High Performance Driver must
use a fixed IP address, e.g. 192.168.0.99.

SkLineScan Start-up

• Start SkLineScan. A start-up dialog box pops up
and displays the connected cameras that have
been automatically detected.

Camera Setup

Use the Setup dialog for
• activating/deactivating a connected
GigE camera (activated device is
ticked)
• changing the IP address
• changing the pixel frequency
• setting the bit depth of the video
signal to 8 or 12-bit.
The MAC addresses are displayed for identification of each camera with the defined CamID (0, 1, ...). This is
useful when several cameras with the same name are connected.

Initial Function Test

• Quit the SkLineScan startup dialog
box.
• Select "OK" in the SkLineScan
start-up dialog.
The Signal Window showing the current
brightness versus the pixel number
indicates the correct installation.
10
of the Network Adapter:
9014 Bytes
2048
extreme
OFF
SK7500GTO-XL Instruction Manual (11.2015)
D
Network Controller Properties: Note, the terms
can differ depending on the installed Ethernet
card and driver.
Desktop Icon
SkLineScan Setup dialog
2 Installation and Setup
© 2015
Schäfter + Kirchhoff GmbH • Hamburg