Toro 74274 Operator's Manual page 53

C
G001042
Figure 72
1. Measure here from blade
to hard surface
7. If the measurements at positions B or C are not
correct, loosen the bolt attaching the rear chain to
the rear support arm (Figure 73).
8. Loosen the jam nut under the rear support arm and
adjust the adjustment bolt to get a measurement of
3-1/8 to 3-1/4 inches (Figure 73).
Note: It is recommended that both sides of the
mower are adjusted the same distance.
9. Tighten the jam nut under the rear support arm
and tighten the bolt securing the chain to the rear
support arm.
10. Adjust the opposite side if needed.
2
1
3
Figure 73
1. Rear chain
2. Rear support arm
3. Bolt
4. Jam Nut
B
2
1
2. Measure at B and C
6
7
4
5
G001040
5. Adjustment bolt
6. Front swivel
7. Front support arm
Adjusting the Front-to-Rear Mower
Pitch
1. Position the right blade front-to-rear (Figure 74).
2. Measure the right blade at the A location, from a
level surface to the cutting edge of the blade tip
(Figure 74).
G001041
1. Measure here from blade
to hard surface
3. Record this measurement.
4. Measure the right blade at the B location, from a
level surface to the cutting edge of the blade tip
(Figure 74).
5. Record this measurement.
6. The mower blade should be a 1/4 to 3/8 inch
(6 to 10 mm) lower at position A than at position
B (Figure 74). If it is not correct, proceed to the
following steps.
Note: Both of the front swivels need to be adjusted
the same amount to maintain equal chain tension.
7. Loosen the front swivel jam nuts, at the front of
the right and left swivels, approximately a 1/2 inch
(13 mm) (Figure 73).
8. Adjust the lift nuts on both the left and the right
side of the machine to achieve 1/4 to 3/8 inch
(6 to 10 mm) lower in front at A than in the rear at
B (Figure 73).
9. Tighten both swivel jam nuts against the front swivel
to lock the height.
10. Check to make sure there is equal tension on the
chains and adjust again if needed.
Adjusting the Compression Spring
1. Raise the mower lift lever to the transport position.
53
2
A
B
Figure 74
2. Measure at A and B
1