Changing The Engine Oil - Toro 74274 Operator's Manual

Checking the Engine Oil Level
Service Interval: Before each use or daily
Note: Check the oil when the engine is cold.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean around the oil dipstick (Figure 34) so dirt
cannot fall into the filler hole and damage the engine.
4. Pull the oil dipstick out and wipe the metal end clean
(Figure 34).
5. Slide the oil dipstick fully into the filler tube. Pull the
dipstick out and look at the metal end (Figure 34). If
the oil level is low, slowly pour only enough oil into
the fill hole to raise the level to the full mark.
Important: Do not overfill the crankcase with
oil because this may cause engine damage. Do
not run the engine with oil below the low mark
because the engine may be damaged as a result.
1
Figure 34
1. Oil dipstick
2. Metal end

Changing the Engine Oil

Service Interval: After the first 50 hours
2
3
G001057
3. Rear left side of machine
Every 100 hours
1. Start the engine and let it run for five minutes. This
warms the oil so it drains better.
2. Park the machine on a level surface.
3. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
5. Place a pan below the oil drain. Remove the drain
plug and let the oil drain completely (Figure 35).
6. Remove the oil filler cap from the top of the engine
(Figure 37). This will help the oil to drain.
7. Install the drain plug and tighten it to 25-1/2 ft-lb
(35 N•m).
Note: Dispose of the used oil at a recycling center.
1
1. Back of machine
Adding Engine Oil
1. Tilt the seat forward and remove the front engine
panel (Figure 36).
33
2
Figure 35
2. Drain plug
G001058