Using The Rollover Protection System (Rops) - Toro 74274 Operator's Manual

Figure 5
1. Left side fuel tank
Using the Rollover Protection
System (ROPS)
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use
the seat belt.
Ensure that the rear part of the seat is secured
with the seat latch.
2
1
G000962
2. Fuel selector valve
There is no rollover protection when the roll bar
is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Lower the roll bar only when
absolutely necessary.
1. Remove the hairpin cotter pins and remove the two
pins (Figure 7).
2. Lower the the roll bar to the down position. There
are two down positions. See Figure 6 for the
positions.
3. Install the two pins and secure them with the
hairpin cotter pins (Figure 7).
1. Full down position
Important: Ensure that the rear part of the
seat is secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter pins
and remove the two pins (Figure 7).
5. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 7).
16
Figure 6
2. Down position with bagger
installed