Toro 74274 Operator's Manual page 49

With a 72in turbo force side discharge mower
Hide thumbs Also See for 74274:
Table of Contents

Advertisement

4
1
2
1. Cap
2. Baffle
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• If hydraulic fluid is injected into the skin
it must be surgically removed within a few
hours by a doctor familiar with this type of
injury. Gangrene may result if this is not
done.
• Keep body and hands away from pin hole
leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Make sure all hydraulic fluid hoses and
lines are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to hydraulic system.
Replacing the Hydraulic Filter and Oil
Service Interval: After the first 25 hours—Change the
hydraulic filter and check hydraulic
oil level.
Yearly—Change the hydraulic filter
and oil.
Use summer filter above 32°F (0°C)
Use winter filter below 32°F (0°C)
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
G001045
Figure 66
3. Cold fluid level-full
4. Hot fluid level-full
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3
Important: Do not substitute automotive oil
filter or severe hydraulic system damage may
result.
3. Place drain pan under filter, remove the old filter
and wipe the filter adapter gasket surface clean
(Figure 67).
1. Hydraulic filter
4. Remove the righthand hydraulic line that comes into
the adapter (Figure 68).
5. Allow the oil to drain out of the system into the
drain pan.
6. Install the righthand hydraulic line to the adapter
(Figure 68).
1
2
1. Righthand hydraulic line
2. Hydraulic filter
7. Apply a thin coat to the rubber gasket on the
replacement filter (Figure 69).
8. Install the replacement hydraulic filter onto the filter
adapter. Do not tighten.
9. Fill the hydraulic tank with hydraulic fluid until the
fluid overflows the filter and then turn the oil filter
clockwise until the rubber gasket contacts the filter
49
1
G001044
Figure 67
G001313
Figure 68
3. Hydraulic tank
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z595-d z master

Table of Contents