Raising The Front Of The Machine; Lubrication; Greasing The Bearings - Toro 74780 Operator's Manual

Raising the Front of the
Machine
If you need to raise the front of the machine, use the very
front edge as shown in Figure
Important: To prevent damage to the steering
mechanism, ensure that the very front edge of the
machine is used for jacking points.
Figure 21
21.

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all the lubrication
points.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, and disengage the
blade-control switch.
2. Engage the parking brake, shut off the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3. Clean the grease fittings with a rag
Figure 23).
Note: Make sure to scrape any paint off the front of
the fitting(s).
1. Front caster tire
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check the tire pressure
every 25 operating hours.
4. Connect a grease gun to each fitting
Figure 23).
5. Pump grease into the fittings until grease begins to
ooze out of the bearings.
26
(Figure 22
Figure 22
Figure 23
3. Grease every 25 operating
hours.
4. Engine
(Figure 22
and
and