Toro 74780 Operator's Manual page 13

Hide thumbs Also See for 74780:
Table of Contents

Advertisement

Throttle/Choke Control
The throttle and choke are combined into 1 control lever.
The throttle controls the engine speed and it has a continuous
variable setting from S
LOW
moving the lever past the Fast setting until it stops
Blade-Control Switch (Power Take-off)
The blade-control switch, (PTO), engages and disengages
power to the mower blades
Fuel-Presence Window
Use the fuel window, located on the left side of the machine,
to verify the presence of gasoline in the tank
Height-of-Cut Lever
The height-of-cut lever allows you to lower and raise the deck
from the seated position. When you raise the lever (toward
you), the deck is raised from the ground, and when you lower
it (away from you), it lowers to the ground. Adjust the height
of cut only while the machine is not moving
Key Choice
®
Switch
This switch allows you to mow in reverse when it is activated.
To activate it, turn the switch to the O
it after the PTO is engaged. To deactivate it, disengage the
PTO
(Figure
6).
Operating-in-Reverse Warning Light
The operating-in-reverse warning light illuminates
whenever you use the KeyChoice key to deactivate the
operating-in-reverse interlock. It is a reminder that the
interlock system is deactivated. The light goes out whenever
you disengage the PTO or shut off the engine. When the light
is on, look behind you and use extra caution when backing up.
SmartPark
Switch
The parking brake is activated electronically.
Engage the parking brake by 1 of the following actions:
Press the SmartPark
5).
The parking brake engages automatically when the
operator leaves the seat and the traction-control pedal is
in N
position.
EUTRAL
The parking brake automatically engages 5 to 6 seconds
after the ignition switch is turned to the O
not already engaged).
To disengage the parking brake, press the Smartpark switch
to the O
position with the key in the R
FF
to F
. Engage the choke by
AST
(Figure
(Figure
5).
(Figure
(Figure
position and release
N
switch to the O
position
N
position (if
FF
position.
UN
5).
6).
14).
(Figure
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timecutter sw 320074781

Table of Contents