Toro 74780 Operator's Manual page 23

WARNING
Loading a machine onto a trailer or truck increases
the possibility of tip-over and could cause serious
injury or death.
• Use extreme caution when operating a machine
on a ramp.
• Use only a full-width ramp; do not use individual
ramps for each side of the machine.
• Do not exceed a 15-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
• Ensure that the length of ramp is at least 4 times
as long as the height of the trailer or truck bed
to the ground. This ensures that the ramp angle
does not exceed 15 degrees on flat ground.
• Back up ramps and drive forward down ramps.
• Avoid sudden acceleration or deceleration while
driving the machine on a ramp as this could
cause a loss of control or a tip-over situation.
6
1. Full-width ramp in stowed
position
2. Side view of full-width
ramp in loading position
3. Not greater than
15 degrees
23
1
2
5
Figure 20
4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground.
5. H= height of the trailer or
truck bed to the ground
6. Trailer
g027996