To Turn On A Surface Burner; To Start The Bake Burners; Step 8, Check The Ignition Of Surface Burners And Oven Burners - Samsung NX58F5700WS Installation Manual

3. Place the left, center, and
right surface burner grates on the
cooktop. The edges of the grates
should match up with the edges
of the cooktop.
Step 8. Check the ignition of surface burners and oven
burners
Check the operation of all cooktop and oven burners after the range has been
installed and assembled, gas supply lines have been carefully checked for leaks,
and electrical power cord has been plugged in.
All surface and oven burners have electronic ignition.
To turn on a surface burner:
1o Push in and turn the control knob
for that surface burner to the LITE
position. The "clicking" sound
indicates the electronic ignition
system is operating properly. The
burner will light in about 4 seconds,
after the air has been purged from
the supply line.
2. After the burner lights, turn the
control knob to the desired setting.
The "clicking" sound will stop and the flame height will change from Max. to
Min. during turning the control knob.
3. The dual valve located in the farthest to the right
controls the inner/outer flame of the dual burner (RF).
When the inner/outer flame is on the HI position, the
flame size gets smaller from the outside when turning
the knob from HI to LO. To control the inner flame, push
and turn the know once again at the position where it
starts to control inner flame.
To start the bake burners:
1=
Press the BAKE pad. The oven will beep every time a
pad is pressed.
The default temperature 350 ° and the Start indicator
will blink on the display. If the default temperature is the
desired cooking temperature, skip to step 2.
34 nstataton instructions