Assembling The Grass Bag - Toro TurfMaster 22205TE Operator's Manual

2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
3. If the crankcase is empty, add about 3/4 of the
crankcase capacity of oil into the oil-fill tube
Note: Max. fill: 0.85 L (29 oz) with oil filter; 0.65 L
(22 oz) without oil filter; type: SAE 30 or SAE 10W30
weight detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.
G01981 1
Figure 7
1. Dipstick
2. Full mark
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the filler neck, then remove it.
Note: To ensure an accurate oil level reading, install
the dipstick fully.
6. Read the oil level on the dipstick
•
If the oil level is below the Add mark, add a small
amount of oil slowly to the oil-fill tube, then repeat
steps 4 through 6
mark on the dipstick.
•
If the oil level above the Full mark, drain the excess
oil until the oil level is at the Full mark on the
dipstick; refer to
19).
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
7. Insert the dipstick into the filler neck and rotate the cap
clockwise until it is tight.
(Figure
3. Add mark
4. Oil-fill tube
(Figure 7).
until the oil level is at the Full
Changing the Engine Oil (page
4
7).

Assembling the Grass Bag

No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
1
2
1. Handle
2. Frame
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame
8
3
Figure 8
3. Grass bag
(Figure 9).
Figure 8.
g027717
(Figure 8).