Controls; Specifications; Operation; Checking The Engine-Oil Level - Toro TurfMaster 22205TE Operator's Manual

Controls

1 2
Figure 12
Throttle (throttle lever not shown for the sake of clarity)
1. Choke
2. Fast
1
2
Figure 13
Control bar
1. Handle

Specifications

Model Weight
22205TE 72 kg
(159 lb)
3 4
g019652
3. Slow
4. Stop
2. Control bar
Length Width Height
175 cm 81 cm
(69 (32
inches) inches)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
Each time before you mow, ensure that the self-propel drive
and the control bar operate properly. When you release the
control bar, the blades and the self-propel drive should stop.
If they do not, contact an Authorized Service Dealer.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
Before each use, ensure that the oil level is between the Add
and Full marks on the dipstick
1. Dipstick
G019669 2. Full mark
1. Move the machine to a level surface.
2. Clean around the dipstick
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the filler neck, then remove it.
Note: To ensure an accurate oil level reading, install
the dipstick fully.
6. Read the oil level on the dipstick
97 cm
(38-1/2
•
If the oil level is below the Add mark, add a small
inches)
amount of oil slowly to the oil-fill tube, then repeat
steps
mark on the dipstick.
•
If the oil level above the Full mark, drain the excess
oil until the oil level is at the Full mark on the
dipstick; refer to
19).
10
(Figure 14).
G01981 1
Figure 14
3. Add mark
4. Oil-fill tube
(Figure 14).
(Figure
4 through 6 until the oil level is at the Full
Changing the Engine Oil (page
14).