Adjusting The Self-Propel Cable; Cleaning Under The Machine - Toro TurfMaster 22205TE Operator's Manual

2. Steady each blade with a board and turn the blade bolt
clockwise with a torque wrench as shown in
torque each blade bolt to 82 N-m (60 ft-lb).
Figure 40
Important: A bolt torqued to 82 N-m (60 ft-lb) is
very tight. Put your weight behind the wrench and
tighten the bolt securely. This bolt is very difficult
to overtighten.
3. Rotate the installed blade 1/4 turn until it is vertical,
and install the other blade in the same manner as the
first (refer to step 1).
Note: The blades should be perpendicular, forming
an inverted "T" as shown in
1
Figure 41
1. Blade (2)
4. Tighten the second blade; refer to step 2.
5. Rotate the blades by hand a full 360° turn to ensure
that they do not touch.
Note: If the blades touch each other, they are not
mounted correctly. Repeat steps
blades no longer touch each other.
Figure 40;
g016537
Figure 41.
G016536
1 through 3 until the
WARNING
Incorrectly installing the blades could damage
the machine or cause an injury to the operator
or to bystanders.
Adjusting the Self-Propel
Cable
If the machine does not self-propel or tends to creep forward
when you release the control bar, adjust the drive cable.
1. Stop and wait for all moving parts to stop.
2. Loosen the cable-support nut
1. Cable-support nut
3. Slide the cable-support nut toward the machine to
increase the self-propel action; slide the cable-support
nut away from the machine to decrease the self-propel
action.
4. Tighten the cable-support nut.
5. Check the operation for the desired drive control, and
repeat the steps above, if necessary.
Note: If the machine creeps forward without the
control bar engaged or if the wheels spin when you
lift the rear wheels off the ground, the cable is too
tight; loosen the cable-support nut, pull the cable jacket
upward (away from the machine) slightly, and tighten
the cable-support nut.
Note: You may also adjust the maximum ground
speed (when the control bar is fully engaged) as desired.

Cleaning under the Machine

For optimal cutting performance, keep the underside of the
machine housing clean. You may either wash or scape the
clippings away from under the machine housing.
Washing under the Machine
Service Interval: Before each use or daily—Clean under the
machine housing.
24
(Figure 42).
1
G019876
Figure 42