Adjusting The Handle Height; Filling The Crankcase With Oil - Toro TurfMaster 22205TE Operator's Manual

Figure 4
1. Bolt (2)
2. Rotate the handle rearward to the operating position.
3. Secure the handle to the machine with the bolts that
you removed in step 1.
4. Tighten the fasteners that support the handle on both
sides of the machine as shown in
1
Figure 5
1. Install a cable tie here.
2. Nut on handle support
bracket (2)
5. Install a cable tie to secure the cables to the lower
handle in the location shown in
the excess material from the tie.
2
1
G028426
2. Nut on handle support
bracket (2)
Figure 5.
2
3
G028427
3. Bolt (4)
Figure 5 and trim off
2

Adjusting the Handle Height

No Parts Required
Procedure
1. Stand in the operating position to determine the most
comfortable handle height.
2. Remove the handle bolt and insert it in 1 of the 3 holes
located at the bottom of the handle bracket
1. Lowest handle height
setting
2. Middle handle height
setting
3. Tighten the handle bolt until it is snug.
4. Repeat the steps above for the other side of the
machine.
3

Filling the Crankcase with Oil

No Parts Required
Procedure
Important: This machine does not come with oil in the
engine. Before starting the engine, fill the engine with
oil.
1. Move the machine to a level surface.
7
(Figure
1
2
3
G021 150
Figure 6
3. Highest handle height
setting
6).