Adjusting the Motion-Control
Damper
The top damper-mounting bolt can be adjusted to obtain a
more desired motion-control lever resistance. See
for mounting options.
RH Motion Control Shown
1. Torque the locknut to 23 N-m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Figure 66
Figure 66
Adjusting the Motion Control
Neutral-Lock Pivot
The flanged nut can be adjusted to obtain a more desired
motion-control lever resistance when moving it to the
neutral-lock position. See
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
Note: For more resistance, tighten the flanged nut.
Note: For less resistance, loosen the flanged nut
3. Tighten the jam nut.
1. Flanged nut
47
Figure 67
for adjustment options.
Figure 67
2. Jam nut