Operating The Throttle; Operating The Choke; Operating The Ignition Switch - Toro 74141 Operator's Manual

Operating the Throttle

The throttle control can be moved between Fast and Slow
positions (Figure 14).
Always use the Fast position when turning on the mower
deck with the blade-control switch (PTO).

Operating the Choke

Use the choke to start a cold engine.
1. If the engine is cold, use the choke to start the engine.
2. Pull up on the choke knob to engage the choke before
using the ignition switch
3. Push down on the choke to disengage the choke after
the engine has started
1
2
1. On position
G008946
Figure 14
(Figure 15).
(Figure 15).
G008959
Figure 15
2. Off position

Operating the Ignition Switch

1. Turn the ignition key to the Start position
Note: When the engine starts, release the key.
Important: Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15 second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to stop to stop the engine.
19
(Figure
G008947
Figure 16
16).