Dell PowerEdge T20 Owner's Manual page 80

Error Message Description
Diskette read The floppy disk may be defective or a cable may be loose. If the drive access light
failure turns on, try a different disk.
Diskette subsystem The floppy drive controller may be faulty.
reset failed
Gate A20 failure One or more memory modules may be faulty or improperly seated. Reinstall the
memory modules and, if necessary, replace them.
General failure The operating system is unable to carry out the command. This message is usually
followed by specific information—for example, Printer out of paper. Take the
appropriate action to resolve the problem.
Hard-disk drive The hard drive failed initialization.
configuration error
Hard-disk drive The hard drive failed initialization.
controller failure
Hard-disk drive The hard drive failed initialization.
failure
Hard-disk drive The hard drive failed initialization.
read failure
Invalid The system configuration information does not match the hardware configuration.
configuration
information-please
run SETUP
program
Invalid Memory DIMM1 slot does not recognize a memory module. The module should be re-
configuration, seated or installed.
please populate
DIMM1
Keyboard failure A cable or connector may be loose, or the keyboard or keyboard/mouse controller
may be faulty.
Memory address A memory module may be faulty or improperly seated. Reinstall the memory
line failure at modules and, if necessary, replace them.
address, read value
expecting value
Memory allocation The software you are attempting to run is conflicting with the operating system,
error another program, or a utility.
Memory data line A memory module may be faulty or improperly seated. Reinstall the memory
failure at address, modules and, if necessary, replace them.
read value
expecting value
Memory double A memory module may be faulty or improperly seated. Reinstall the memory
word logic failure modules and, if necessary, replace them.
at address, read
80