Recording - Onkyo MD-101A Instruction Manual

Recording

Analog recording
Recording analog data (data input via the
connected audio pin cable)
1
Press the STANDBY/ON button.
The STANDBY indicator goes out.
2
Load a recordable MD.
MINIDISC RECORDER
DISC LOADIING MECHANISM
INPUT
STANDBY / ON
STANDBY
DISPLAY
Number of recorded
tracks on MD
Note
When "Protected" is shown in the display, it
indicates that the record-protect tab of the
MD is open. Before starting the recording
procedure, close the tab. (See page 34.)
24
STANDBY / ON
STANDBY/ON
STANDBY
DISPLAY
STANDBY / ON
STANDBY
Insert an MD
MULTI JOG
EDIT / NO YES
with the label
CD
REC MODE DUBBING REC
PUSH TO ENTER
side up, in the
direction of
the arrow.
MD - 101 A
Total recorded time
MINIDISC RECORDER
DISC LOADIING MECHANISM
CD
INPUT REC MODE DUBBING
INPUT REC MODE
To check the time remaining for
recording
When the MD recorder is stopped, press the
DISPLAY button. Each press of the DISPLAY
button changes the display as follows:
The number of tracks on MD and the total
recorded time
MD
To record by erasing all of the existing
tracks on a prerecorded MD
Erase all the tracks before you start
recording (see page 36).
3
Press the INPUT button repeatedly
until "Analog In" appears.
INPUT
Note
• Make sure that the INPUT button and the
REC button on the amplifier are set to an
appropriate recording source.
4
Select a recording mode.
Refer to Step 4 on page 22 to select a
recording mode.
5
Play the recording source.
If a CD player (such as the C-701A) has
been connected to the system, start
playing the CD or tape player.
MULTI JOG
EDIT / NO YES
REC
PUSH TO ENTER
MD - 101 A
Remaining recording time on
Disc name ("No Name" when not set)
ANALOG IN
REC MODE